VIN 3MABM1256JR627248

SOME LAP SHOULDER BELT RETRACTORS WERE BUILT WITH CERTAIN OUT OF TOLERANCE COMPONENTS.

RETRACTORS MAY LOCK AT LOW BELT PULL OUT RATES, THISCOULD DISCOURAGE SEAT BELT USAGE.

REPLACE FRONT LAP SHOULDER BELT ASSEMBLIES, AS NECESSARY.

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THAT LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

INCORRECT FUEL FILLER NECK ATTACHMENT SCREWS WERE USED TO ATTACH THE NECK TO THE REAR QUARTER PANELS.

THIS CONDITION COULD CAUSE A RATTLE BETWEEN THE FUELFILLER PIPE AND THE SURROUNDING BODY STRUCTURE.

REPLACE INCORRECT SCREWS WITH NEW BOLT/WASHER ASSEMBLIES.