1MELM6538TK626393

FEDERAL MOGUL IS RECALLING 6,903 AFTERMARKET BALL JOINT ASSEMBLIES SHIPPED BETWEEN NOVEMBER 9, 2007 AND MARCH 26, 2008, WHICH MAY HAVE BEEN PACKAGED WITH INCORRECT NUTS. THE PART NUMBERS PACKAGED WITH INCORRECT NUTS ARE: K7147, K7329, K8683, AND 104353. THESE PARTS WERE MADE FOR USE ON THE VARIOUS VEHICLES LISTED ABOVE.

THE NUTS INCLUDED IN THE PACKAGING FOR THESE BALL JOINT ASSEMBLIES ARE MISSING THE INTENDED PREVAILING TORQUE (SELF-LOCKING) FEATURE. IF THE INCORRECT NUT WAS TO BECOME LOOSE, THE JOINING MEMBERS MAY LOOSEN LEADING TO A SEPARATION OF THE BALL JOINT. THIS MAY RESULT IN LOSS OF VEHICLE CONTROL, POSSIBLY RESULTING IN A VEHICLE CRASH.

FEDERAL MOGUL WILL NOTIFY OWNERS AND REPLACE THE PARTS FREE OF CHARGE. THE RECALL BEGAN ON MAY 22, 2008. OWNERS CAN CONTACT FEDERAL MOGUL AT 877-489-6659.

CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK.

LOSS OF BRAKE FLUID CAN LEAD TO A DECREASE IN BRAKE LINE PRESSURE AND AN INCREASE IN STOPPING DISTANCE, WHICH CAN RESULT IN A VEHICLE CRASH.

AFFINIA (BRAKE PARTS, INC.) WILL REPLACE THE SUBJECT BRAKE HYDRAULIC MASTER CYLINDERS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2006. OWNERS CAN CONTACT AFFINA GROUP CUSTOMER SERVICE AT 1-800-323-0354.

VEHICLE DESCRIPTION: 1995 PASSENGER VEHICLES EQUIPPED WITH THE 2.0L AND 2.5L ENGINES, AND 1996 VEHICLES EQUIPPED WITH 2.5L ENGINES. TIGHTENING OF THE ENGINE COOLING FAN MOTOR BEARINGS, UP TO AND INCLUDING MOTOR STALL, CAN RESULT IN INCREASED MOTOR TORQUE AND HIGHER THAN NORMAL MOTOR CURRENT AND ACCOMPANYING HIGH MOTOR TEMPERATURES.

OVERHEATING OF THE COOLING FAN MOTOR DUE TO EXCESSIVE CURRENT CAN RESULT IN SMOKE AND ODORS FROM BEARING GREASE, INSULATION AND OTHER INTERNAL MOTOR COMPONENTS. IF ELECTRICAL CURRENT CONTINUES TO BE APPLIED TO THE MOTOR, INTERNAL MOTOR COMPONENTS COULD IGNITE POSSIBLY IGNITING OTHER ENGINE COMPARTMENT COMPONENTS.

DEALERS WILL INSTALL A POSITIVE TEMPERATURE COEFFICIENT DEVICE IN-LINE WITH EACH FAN MOTOR. FORD WILL ALSO EXTEND THE WARRANTY ON THE ENGINE COOLING FAN ASSEMBLY TO A TOTAL OF 8 YEARS OF SERVICE OR 100,000 MILES FROM THE WARRANTY START DATE, WHICHEVER OCCURS FIRST. IF THE VEHICLE ALREADY HAS MORE THAN 100,000 MILES, THIS COVERAGE WILL LAST UNTIL JULY 31, 2001.

VEHICLE DESCRIPTION: PASSENGER VEHICLES NOT EQUIPPED WITH THE ANTI-LOCK BRAKING SYSTEM (ABS). A PRESSURE CONSCIOUS REDUCING VALVE (PCRV) IN THE REAR BRAKES MAY BE SUBJECT TO CORROSION AND RESULT IN MALFUNCTION, WHEN OPERATED IN AREAS THAT USE SALT COMPOUNDS ON THE ROADWAY FOR DE-ICING OR DUST CONTROL.

IF BOTH PCRV'S MALFUNCTION, VEHICLE HANDLING COULD BE ADVERSELY AFFECTED DURING BRAKING AS A RESULT OF THE REAR WHEELS LOCKING, INCREASING THE RISK OF A CRASH.

DEALERS WILL INSTALL IMPROVED PCRV'S IN THE REAR BRAKE SYSTEM. THIS RECALL WAS EXPANDED IN SEPTEMBER 2000 TO INCLUDE 1999 AND 2000 FORD CONTOUR, MERCURY MYSTIQUE AND COUGAR VEHICLES.

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1995-1997 FORD CONTOUR AND MERCURY MYSTIQUE VEHICLES. THE HEATER BLOWER RESISTOR COULD OVERHEAT CAUSING THE ATTACHED ELECTRICAL CONNECTOR TO MELT.

THIS COULD CREATE THE POTENTIAL FOR A FIRE.

FORD WILL PROVIDE ADDITIONAL WARRANTY COVERAGE FOR THE HEATER BLOWER SWITCH FOR 10 YEARS FROM ORIGINAL DATE OF SALE OF THE VEHICLE OR 150,000 MILES, WHICHEVER COMES FIRST. DEALERS WILL INSTALL A NEW HEATER BLOWER RESISTOR AND A NEW WIRE JUMPER HARNESS FREE OF CHARGE.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FUEL FILLER PIPE VENT HOSE MAY HAVE LESS THAN THE INTENDED LEVEL OF OZONE RESISTANCE, WHICH COULD RESULT IN THE HOSE BECOMING BRITTLE AND CRACKING.

A CRACKED HOSE COULD RESULT IN FUEL LEAKAGE WHEN THE VEHICLE IS BEING FUELED.

DEALERS WILL INSTALL A FUEL FILLER VENT HOSE CONTACTING THE APPROPRIATE BLEND OF PVC AND NITRILE RUBBER.

ON CERTAIN MY 1996-1998 PASSENGER VEHICLES BUILT AT THE KANSAS CITY, CUAUTITLAN ASSEMBLY PLANTS OR ON MY 1999 PASSENGER VEHCLES BUILT AT THE AUTOMOTIVE ALLIANCE INTERNATIONAL ASSEMBLY PLANTS, THE ROUGH SURFACE OF THE HEATER BLOWER RESISTOR'S STAINLESS STEEL BLADES CAN DAMAGE THE COPPER SURFACE OF THE WIRING HARNESS CONNECTOR. THE DAMAGE COULD, OVER TIME, CAUSE INCREASED RESISTANCE IN THE CONNECTOR AND, DUE TO SUBSEQUENT TERMINAL RELAXATION, RESULT IN AN OPEN CIRCUIT CONDITION.

THE OPEN CIRCUIT COULD LEAD TO ELECTRICAL ARCING THAT COULD MELT THE CONNECTOR HOUSING MATERIAL CREASING THE POTENTIAL FOR A FIRE.

DEALERS WILL INSTALL A NEW HEATER BLOWER RESISTOR AND A NEW WIRE JUMPER HARNESS. OWNER NOTIFICATION BEGAN AUGUST 29, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-392-3673.

VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH THE TRACTION CONTROL OPTION. THE THROTTLE CABLES WERE DAMAGED DURING VEHICLE ASSEMBLY LEADING TO FRAYING OR SEPARATION OF THE THROTTLE CABLE.

THIS CONDITION COULD PREVENT THE ENGINE FROM RETURNING TO IDLE.

DEALERS WILL REPLACE THE THROTTLE CABLE WITH A REVISED DESIGN THAT IS LESS SUSCEPTIBLE TO BENDING OR KINKING DURING INSTALLATION.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FLOOR SHIFT AUTOMATIC TRANSMISSION CONTROL CAN BE DAMAGED IF SUBJECTED TO CERTAIN INTERIOR CLEANING PRODUCTS. THE GEAR POSITION INDICATOR CAN DETERIORATE AND NOT CORRECTLY INDICATE THE ACTUAL GEAR POSITION.

THIS CONDITION CAN RESULT IN INCORRECT GEAR SELECTION.

DEALERS WILL REPLACE THE AUTOMATIC TRANSMISSION FLOOR SHIFT CONTROL.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE TERMINALS AT THE HEADLIGHT SWITCH AND WIRING HARNESS CONNECTOR CAN EXPERIENCE HEAT DAMAGE AS A RESULT OF OVERHEATING.

THE DAMAGE COULD RESULT IN DISTORTION OF THE TERMINAL CAUSING AN OPEN CIRCUIT IN THE INSTRUMENT PANEL ILLUMINATION, PARKING LAMP, AND TAIL LAMP CIRCUITS.

DEALERS WILL INSTALL A HEADLAMP SWITCH WIRING CONNECTOR CONTAINING BRONZE TERMINALS AND AN INSPECTION, AND REPLACEMENT IF NECESSARY, OF THE HEADLAMP SWITCH.