1G2WJ14W7KF255387

CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.

HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).

VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA, WHERE ROAD SALT USE IS HEAVY. A CONDITION WHERE ONE OR BOTH FRONT ENGINE CRADLE BOLTS CAN PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINERS.

IF BOTH BOLTS PULL THROUGH, THE FRONT OF THE CRADLE WOULD NO LONGER BE SUPPORTED AT THE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT COULD SEPARATE FROM THE STEERING GEAR.

DEALERS WILL REPLACE THE FRONT AND REAR FRAME/CRADLE BOLTS AND RETAINERS.

CRACKS DEVELOP IN THE WHEEL MOUNTING SURFACE. IF THESE CRACKS BECOME SEVERE ENOUGH, THE WHEEL WILL COMPLETELY SEPARATE FROM THE VEHICLE.

IF WHEEL SEPARATION OCCURS WHILE THE VEHICLE IS IN MOTION, LOSS OF STEERING AND BRAKE CONTROL OF THE VEHICLE OCCURS, AND A VEHICLE CRASH COULD RESULT WITHOUT PRIOR WARNING.

DEALERS WILL INSPECT THE MANUFACTURING DATE CODES STAMPED ON EACH WHEEL OF THE VEHICLE AND IF A WHEEL FALLS WITHIN THE SPECIFIED DATE CODE RANGE, THE DEALER WILL REPLACE THAT WHEEL ASSEMBLY.

CRACKS DEVELOP IN THE WHEEL MOUNTING SURFACE. IF THESE CRACKS BECOME SEVERE ENOUGH, THE WHEEL WILL COMPLETELY SEPARATE FROM THE VEHICLE.

IF WHEEL SEPARATION OCCURS WHILE THE VEHICLE IS IN MOTION, LOSS OF STEERING AND BRAKE CONTROL OF THE VEHICLE OCCURS, AND A VEHICLE CRASH COULD RESULT WITHOUT PRIOR WARNING.

DEALERS WILL INSPECT THE MANUFACTURING CODES STAMPED ON EACH WHEEL OF THE VEHICLE AND IF A WHEEL FALLS WITHIN THE SPECIFIED DATE CODE RANGE, THE DEALER WILL REPLACE THAT WHEEL ASSEMBLY.

BRAKE STOPLAMPS MAY NOT ILLUMINATE OR, IN SOME CASES, STOPLAMPS MAY NOT STAY ILLUMINATED ALL THE TIME WHEN BRAKES ARE APPLIED DUE TO A FAULTY STOPLAMP SWITCH. ALSO, IN VEHICLES WITH CRUISE CONTROL, A FAULTY STOPLAMP SWITCH CAN RESULT IN RESUMPTION OF THE CRUISE CONTROL FUNCTION UPON RELEASE OF THE BRAKE PEDAL.

A TRAILING VEHICLE MAY NOT RECOGNIZE A BRAKING ACTIONIN TIME TO RESPOND APPROPRIATELY. ALSO, CRUISE CONTROL WILL REENGAGE UPONRELEASE OF THE BRAKE PEDAL AND RESUME THE SET SPEED. IN EITHER CASE, IT COULDRESULT IN A CRASH WITHOUT PRIOR WARNING.

INSTALL AN IMPROVED DESIGN STOPLAMP SWITCH.

VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.

IF THIS WERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, A VEHICLE CRASH COULD RESULT.

DEALERS WILL REPLACE THE REAR CRADLE BOLTS AND RETAINERS.

MISROUTING OF TURBOCHARGER OIL FEED PIPE COULD ALLOW PIPE TO CONTACT THE POSITIVE BATTERY CABLE CONNECTING STUD ON THE STARTER MOTOR.

THIS COULD CAUSE AN ELECTRICAL GROUND THAT COULD RESULTIN AN ENGINE COMPARTMENT FIRE.

REROUTE OIL FEED PIPE; ALSO INSTALL A NEWLY DESIGNED CLAMP AND BRACKET TO LOCATE PIPE AWAY FROM THE STARTER.

FRONT SHOULDER BELT GUIDE LOOP ATTACHMENT FASTENER MAY PULL THROUGH DOOR MOUNTED ANCHOR PLATE.

SEAT BELT MAY NOT SUSTAIN LOADS REQUIRED BY FMVSS 210, AND IN A VEHICLE ACCIDENT, THE SEAT BELT MAY NOT PROPERLY RESTRAIN A PASSENGER, RESULTING IN INCREASED RISK OF GREATER INJURY TO AN OCCUPANT.

REPLACE FRONT SHOULDER BELT GUIDE LOOP ATTACHMENT NUTS AND INSTALL NEW GUIDE COVER.

BRAKE STOPLAMPS MAY NOT ILLUMINATE OR, IN SOME CASES, STOPLAMPS WILL NOT STAY ILLUMINATED ALL THE TIME WHEN BRAKES ARE APPLIED DUE TO A FAULTY STOPLAMP SWITCH. ALSO IN VEHICLES EQUIPPED WITH CRUISE CONTROL, A FAULTY STOPLAMP SWITCH CAN RESULT IN RESUMPTION OF THE CRUISE CONTROL FUNCTION UPON RELEASE OF THE BRAKE PEDAL.

A TRAILING VEHICLE MAY NOT RECOGNIZE A BRAKING ACTIONIN TIME TO RESPOND APPROPRIATELY. ALSO, CRUISE CONTROL WILL REENGAGE UPONRELEASE OF THE BRAKE PEDAL AND RESUME THE SET SPEED. IN EITHER CASE, IT COULDRESULT IN A CRASH WITHOUT PRIOR WARNING.

INSTALL AN IMPROVED DESIGN STOPLAMP SWITCH.

FUEL RETURN LINES COULD FRACTURE AND ALLOW FUEL TO LEAK IN THE AREA OF THE FUEL TANK.

IN PRESENCE OF AN IGNITION SOURCE, THIS CONDITION COULDRESULT IN A FIRE.

INSTALL NEW FUEL RETURN PIPE ASSEMBLY.