1G1FP23E1ML170051

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.

HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).

POOR BOND ADHESION BETWEEN THE WINDSHIELD GLASS AND THE MOUNTING, WHICH COULD ALLOW THE WINDSHIELD TO SEPARATE FROM THE VEHICLE DURING A COLLISION. THIS FAILS TO CONFORM WITH FMVSS 212.

IF WINDSHIELD SEPARATION OCCURS IN A COLLISION, ANUNBELTED OCCUPANT COULD BE EJECTED FROM THE VEHICLE, AND PERSONAL INJURY COULDOCCUR.

REMOVE ALL SEALER FROM WINDSHIELD AND MOUNTING; APPLY NEW BONDING AND SEALANT MATERIAL, AND REINSTALL WINDSHIELD.

THE FRONT SEAT UPPER HINGE COVER SCREWS ARE TOO LONG, AND INTERFERE WITH THE SEAT BACK INERTIA LOCK. THIS PREVENTS THE SEAT BACK FROM LOCKING PROPERLY.

IN THE EVENT OF A SUDDEN STOP OR VEHICLE IMPACT, ANUNLOCKED SEAT BACK WOULD INCREASE THE RISK OF INJURY TO THE SEAT OCCUPANT.

REPLACE SCREWS SECURING UPPER HINGE TRIM COVER WITH CORRECT LENGTH SCREWS.

THE METAL LATCHPLATES MAY NOT ENGAGE THE BUCKLE ASSEMBLIES, CAUSING A "NO LATCH" CONDITION. MOVEMENT OF THE SEAT OCCUPANT IN THIS CONDITION COULD CAUSE LATCHPLATE RELEASE FROM THE BUCKLE.

UNBELTED OR INCORRECTLY BELTED SEAT OCCUPANTS ARESUBJECTED TO INCREASED RISK OF INJURY IN THE EVENT OF SUDDEN STOP OR ACCIDENT.

REPLACE THE RETRACTOR ASSEMBLY FOR THE SAFETY BELT (FRONT AND REAR IN COUPES AND FRONT ONLY IN CONVERTIBLES).

THE FUEL FILLER NECK SOLDER JOINT CAN DEVELOP CRACKS OR PIN HOLE LEAKS, WHICH DOES NOT COMPLY WITH FMVSS NO. 301, "FUEL SYSTEM INTEGRITY." THE CRACKS AND HOLES CAN ALLOW FUEL VAPOR AND FUEL LEAKAGE.

CONSEQUENCE OF NON-COMPLIANCE: GASOLINE VAPORS AND FUEL LEAKS CAN RESULT IN A FIRE IF EXPOSED TO A SOURCE OF IGNITION.

DEALERS WILL INSPECT THE FUEL TANK ASSEMBLY AND REPLACE THOSE WHICH EXHIBIT THE CRACKS OR PIN HOLE LEAKS.