1G1BL83E3MW222744

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

LACK OF AMBER SIDE REFLECTORS IN THE LAMPS WILL DECREASE LIGHTING VISIBILITY TO OTHER DRIVERS AND MAY POSSIBLY RESULT IN A VEHICLE CRASH.

AJ MOTORSPORT WILL NOTIFY OWNERS AND OFFER REIMBURSEMENT FOR THE LAMPS. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT AJ MOTORSPORT AT 626-618-2026.

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

SYSTEM: ELECTRICAL.VEHICLE DESCRIPTION: SEQ 9C1 POLICE CARS IN CORROSION AREAS OF THE US AND CANADA ONLY. NOTE: VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEWJERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, AND WISCONSIN. A ELECTRICAL GROUND-OUT CONDITION MAY EXIST BETWEEN THE 12 VOLT JUNCTION BLOCK AND THE METAL INNER FENDER SKIRT.

THIS CONDITION CAN CAUSE A MELTED JUNCTION BLOCK, SMOKE,AND BURNED UNDERHOOD WIRING RESULTING IN A DISABLED VEHICLE OR A VEHICLE FIRE.THIS CONDITION CAN OCCUR WHILE THE VEHICLE IS IN OPERATION OR WHILE THE VEHICLEIS PARKED AND THE IGNITION IS IN THE "OFF" POSITION.

INSTALL A SHIELDING INSULATOR UNDER THE JUNCTION BLOCK.

THE REAR LOWER CONTROL ARM CAN CRACK AT THE REAR STABILIZER BAR ATTACHMENT.

THIS CONDITION CAN BE AGGRAVATED BY THE SEVERE DUTY CYCLE OF THESE VEHICLES AND EVENTUALLY CAUSE THE LOWER CONTROL ARM TO FRACTURE COMPLETELY CAUSING A LOSS OF VEHICLE CONTROL WITHOUT PRIOR WARNING.

DEALERS WILL REPLACE BOTH REAR LOWER CONTROL ARMS AND REAR STABILIZER BAR ATTACHMENTS.

THE SHOULDER BELT GUIDE LOOP PLASTIC COVERING MAY CRACK AND EXPOSE THE STEEL SUB-PLATE.

IN THE EVENT OF A VEHICLE CRASH, THE EXPOSED STEELSUB-PLATE CAN CUT THE SAFETY BELT WEBBING RESULTING IN INCREASED POSSIBILITYAND/OR SEVERITY OF INJURY TO THE AFFECTED SEAT OCCUPANT.

INSTALL NEW SHOULDER BELT GUIDE LOOPS.

THE STEEL WHEELS EXHIBIT FATIGUE CRACKING AROUND THE CIRCUMFERENCE OF THE WHEEL LUG NUT MOUNTING SURFACE DUE TO WHEEL BENDING CAUSED BY FREQUENT MISUSE OF TIRE MOUNTING EQUIPMENT, LUG NUT OVERTORQUING, AND THE UNUSUAL OPERATING CONDITIONS EXPERIENCED BY POLICE VEHICLES.

THE CRACKING CAN CAUSE WHEEL FRACTURING AND SUBSEQUENTSEPARATION FROM THE AXLE, WHICH COULD RESULT IN A VEHICLE ACCIDENT.

REPLACE THE DEFECTIVE WHEELS WITH REDESIGNED STEEL WHEELS.

SECONDARY HOOD LATCH ASSEMBLIES CAN CORRODE, CAUSING A HIGH LATCH RELEASE EFFORT AND POSSIBLY PREVENTING THE HOOD FROM LATCHING PROPERLY WHEN IT IS CLOSED.

IF THE SECONDARY HOOD LATCH IS NOT PROPERLY ENGAGED, ANDTHE PRIMARY HOOD LATCH WAS ALSO NOT ENGAGED, THE HOOD COULD OPEN AND CONTACT THEWINDSHIELD WHILE THE VEHICLE WAS IN MOTION, REDUCING THE FORWARD VISION AREA OFTHE DRIVER AND RESULTING IN A POSSIBLE VEHICLE ACCIDENT WITHOUT PRIOR WARNING.

INSTALL A NEW SECONDARY HOOD LATCH ASSEMBLY.