1FALP57U8TG261621

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

THE PARK PAWL SHAFT WAS IMPROPERLY POSITIONED WHEN THE ROLL PIN THAT RETAINS IT WAS INSTALLED DURING TRANSMISSION ASSEMBLY. IF THE SHAFT WAS NOT PROPERLY POSITIONED, THE ROLL PIN MAY NOT HAVE LINED UP WITH THE GROOVE IN THE SHAFT AND HAVE BEEN CRUSHED AT ASSEMBLY. ALSO, A BURR COULD HAVE BEEN RAISED ON THE SHAFT.

THIS COULD RESULT IN THE PARK PAWL OCCASIONALLY NOT ENGAGING WHEN THE TRANSMISSION SELECTOR LEVER IS PLACED IN THE PARK POSITION. THIS COULD RESULT IN THE VEHICLE ROLLING AS IF IN NEUTRAL IF THE VEHICLE OPERATOR DOES NOT APPLY THE PARKING BRAKE.

DEALERS WILL INSPECT THE PARK PAWL SHAFT ROLL PIN. IF THE ROLL PIN IS DAMAGED, BOTH THE ROLL PIN AND THE PARK PAWL SHAFT WILL BE REPLACED. IN ADDITION, OWNERS WILL BE REMINDED TO FULLY APPLY THE PARKING BRAKE, IN ADDITION TO PLACING THE TRANSMISSION IN PARK.

THE BRAKE SYSTEM FLUID LEVEL INDICATOR LAMP SWITCH CAN MALFUNCTION. THIS DOES NOT COMPLY WITH FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS."

CONSEQUENCE OF NON-COMPLIANCE: IF THE SWITCH MALFUNTIONS, THE BRAKE SYSTEM WARNING LAMP WILL EITHER REMAIN ILLUMINATED CONTINUOUSLY OR FAIL TO LIGHT AS INTENDED WHEN THE FLUID LEVEL FALLS TO A CERTAIN LEVEL. IN EITHER CASE, THE VEHICLE OPERATOR WOULD NOT BE WARNED OF A LOW BRAKE FLUID LEVEL CONDITION.

DEALERS WILL REPLACE THE BRAKE SYSTEM FLUID LEVEL INDICATOR LAMP SWITCHES.

VEHICLE DESCRIPTION: PASSENGER VEHICLES PREVIOUSLY SERVICED UNDER FORD SERVICE BULLETIN 97-17-9 FROM AUGUST 1997 THROUGH DECEMBER 1997. THESE VEHICLES WERE INADVERTENLY EQUIPPED WITH AN 18-GALLON FUEL TANK RATHER THAN THE 16-GALLON AS SPECIFIED. THE 18-GALLON TANK HAS A SECOND VALVE LOCATION WHERE A SHIPPING PLUG SHOULD BE INSTALLED.

IF THIS SHIPPING PLUG IS DISPLACED, FUEL LEAKAGE CAN RESULT. FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE COULD POTENTIALLY RESULT IN A FIRE.

DEALERS WILL INSTALL THE CORRECT FUEL TANK.

THE AUTOMATIC TRANSMISSION PARK PAWL SHAFT MAY NOT BE FREE TO ROTATE AS INTENDED. IF THE PARK PAWL SHAFT DOES NOT ROTATE, IT WOULD PREVENT THE PARK PAWL FROM ENGAGING THE PARK GEAR WHEN THE SHIFT LEVER IS IN THE PARK POSITION.

THIS CONDITION COULD RESULT IN THE VEHICLE ROLLING AS IF IN NEUTRAL WITH THE SHIFT LEVER IN THE PARK POSITION.

DEALERS WILL INSPECT THE PARK PAWL SHAFT ROTATION AND THOSE SHAFTS WITH RESTRICTED ROTATION WILL BE REPLACED WITH A SHORTER SHAFT THAT WILL NOT RESTRICT ROTATION.

THE PARK PAWL ABUTMENT BRACKET HAS A SHARP EDGE WHICH CAN CAUSE THE PARKING PAWL TO HANG UP AND NOT ENGAGE THE PARK GEAR. THIS WOULD ALLOW THE VEHICLE TO MOVE EVEN THOUGH THE GEAR SHIFT INDICATOR SHOWS THAT THE VEHICLE IS IN PARK.

UNINTENDED AND UNEXPECTED VEHICLE MOVEMENT CAN RESULT IN PERSONAL INJURY AND PROPERTY DAMAGE.

DEALERS WILL INSPECT AND, IF NECESSARY, REPLACE THE PARK PAWL ABUTMENT BRACKET.

THE FUEL PRESSURE REGULATOR LOCATED ON THE FUEL RAIL IN THE ENGINE COMPARTMENT HAS A VACUUM DIAPHRAGM THAT WAS DAMAGED DURING MANUFACTURE OF THE REGULATOR.

IF THE DIAPHRAGM TEARS OR RUPTURES, LIQUID FUEL COULD ENTER THE INTAKE MANIFOLD PLENUM THROUGH THE VACUUM LINE RESULTING IN EITHER RELEASE OF FUEL FROM THE AIR CLEANER ASSEMBLY OR THE EXHAUST SYSTEM. FUEL RELEASE IN THE PRESENCE OF AN IGNITION SOURCE COULD POTENTIALLY RESULT IN A FIRE.

DEALERS WILL INSPECT THE FUEL PRESSURE REGULATOR. THOSE REGULATORS PRODUCED DURING THE SUSPECT TIME PERIOD WILL BE REPLACED.